Pneumatic Rigs

Pneumatic ‘Buggy’ Production Rigs

Compact and mobile, pneumatic ‘buggy’ production rigs are a popular choice for tight situations such as shaft mines (being easy to disassemble/reassemble and capable of being loading into a lift cage).  Drill depths are typically up to 25m.

 

NOTE: The below does not represent an exhaustive list of compatible rig makes/models (including older models). 

Contact Us if you can’t find your rig model below.  

  • StopMate
  • StopMaster

 

The above Boart Longyear Model Range is FULLY COMPATIBLE with the Minnovare Production Optimiser system.

 

In the case of this type of rig, the entire Production Optimiser system is portable; packing down into a sturdy and durable easy-carry case.  The Opti-Box unit is mounted to the drill rig upon aligning the rig over the collar.  The mobile interface is a handheld device that also packs down securely into the carry-case.  Minnovare’s onsite trials demonstrate that the Production Optimiser system significantly enhances the accuracy of this particular range of rig – on average doubling the number of holes drilled to within tolerance , as well as slashing the overall setup time over each drill hole.

 

  • 5200

 

 

The above Cubex Model Range is FULLY COMPATIBLE with the Minnovare Production Optimiser system.

 

In the case of this type of rig, the entire Production Optimiser system is portable; packing down into a sturdy and durable easy-carry case.  The Opti-Box unit is mounted to the drill rig upon aligning the rig over the collar.  The mobile interface is a handheld device that also packs down securely into the carry-case.  Minnovare’s onsite trials demonstrate that the Production Optimiser system significantly enhances the accuracy of this particular range of rig – on average doubling the number of holes drilled to within tolerance , as well as slashing the overall setup time over each drill hole.

 

  • Stinger

 

 

The above Major Drilling Model Range is FULLY COMPATIBLE with the Minnovare Production Optimiser system.

 

In the case of this type of rig, the entire Production Optimiser system is portable; packing down into a sturdy and durable easy-carry case.  The Opti-Box unit is mounted to the drill rig upon aligning the rig over the collar.  The mobile interface is a handheld device that also packs down securely into the carry-case.  Minnovare’s onsite trials demonstrate that the Production Optimiser system significantly enhances the accuracy of this particular range of rig – on average doubling the number of holes drilled to within tolerance , as well as slashing the overall setup time over each drill hole.

 

Send Us A message